Chapter 3
3-25
2) Remove the three screws [1]. (The external cover is
omitted from the illustration below to show the
instructions clearly.)
3) Remove the four connectors [2] as well as the flat
cable [3] on the DCNT board.
F-3-103
4) As you remove the bosses on both sides [1], lower
the front part of the power supply assembly [2].
Then pull it to remove the power supply assembly.
F-3-104
3.1.14.11 Removing the Power
Supply Board
0005-9912
1) Remove the connector [1] and the flat cable [2].
2) Remove the four screws [3]. As you disengage the
two spacers [4], remove the power supply board
[5].
F-3-105
3.1.15 High-voitage Power Supply
board
3.1.15.1 Removing the Cassette 0002-7494
1) Remove the cassette by holding the cassette handle.
3.1.15.2 Removing the Reader
Right Front Cover
0002-7496
1) Open the platen glass cover [1].
2) Open the front cover [2], remove one screw [3], and
remove the reader right front cover [4].
F-3-106
[1]
[2]
[2]
[1]
[3]
[1]
[2]
[3]
[5]
[3]
[2]
[1]
[4]
[4]
[1]
[4]
[3]
[2]
To Next Page