Carrier TruVu VAVB3-E2 - Page 123

Appendix A: TV-VAVB3-E2 Points/Properties
TruVu™ VAVB3-E2 CARRIER CORPORATION ©2022
Installation and Start-up Guide All rights reserved
117
In the popup, select the Properties > Sensor tab to configure ZS sensors for Setpoint
Adjust.
Edit Increment – Amount of offset in degrees for each press of the up or down arrows
on the ZS Sensor for setpoint adjustment.
D:
R:
1
0.1
0.5
1
Allow Setpoint Adjustment – Check to allow setpoint adjustments on the specified ZS
sensor.
D:
R:
(1) enabled
disabled/enabled
Sensor Setpoint Adjust Option – Check to select the ZS setpoint adjustment display.
D:
3