Carrier TruVu VAVB3-E2 - Act Net Bus

Adjusting the TV-VAVB3-E2 driver properties
TruVu™ VAVB3-E2 CARRIER CORPORATION ©2022
Installation and Start-up Guide All rights reserved
84
Act Net Bus
Act Net Bus Status
An Act Net device that is physically connected to the TV-VAVB3-E2 is automatically identified and the serial
number and current status are displayed on the Act Net Bus page.
NOTE You can edit the address and description on this page. Applying changes can take up to 20 seconds to
complete.
Act Net Bus Status
This table shows devices connected to the Act Net port. All fields are read-only.
Device Address
Act Net device address (1 to 5). The same address is used as exp# in the
microblock configuration with the input/output number for all Act Net devices set
to 1.
Device Description
This text is editable in the Act Net Bus Configuration table directly below.
Serial Number
The serial number of the Act Net device. This number is printed on a label on the
device.
Device Status
Displays the current status of the device
Possible statuses
Description
Normal Operation
Successful communication
No Communication with
the device
TV-VAVB3-E2 has lost communication with the Act Net
device
Duplicate Address on
the network
More than one device has the same Device Address.
Unsupported Device
Type
Device is not recognized
Act Net Wiring Error
Loopback error on Act Net bus, possibly caused by
wiring problem or hardware failure.
Act Net Bus Configuration
This table shows devices connected to the Act Net port. Most fields are editable.
Current Address
Bus address of the Act Net device
Device Description
Edit the name if needed.
Serial Number
Serial Number of the device corresponds to Current Address in the same row. This
field is read-only if the corresponding device is in communication, otherwise
becomes editable so that user can enter the serial number manually (can be found
as a label on the actuator).
New Device Address
Select a new bus address from the drop-down list.