Carrier TruVu VAVB3-E2 - Common Alarms; Specific Events

Adjusting the TV-VAVB3-E2 driver properties
TruVu™ VAVB3-E2 CARRIER CORPORATION ©2022
Installation and Start-up Guide All rights reserved
79
Common Alarms
On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following BACnet
alarms:
Common alarms:
• Duplicate Address
• Control Program
• Controller Halted
• Locked I/O
• Program Stopped
• Excessive COV
• All Programs Stopped
Controller Generated Alarm
Description
Short message shown on the i-Vu® Alarms page or in an alarm action when this
type of alarm is generated.
Events
Alarm Category and Alarm
Template
See Setting up an alarm source in the i-Vu® interface in i-Vu® Help.
Enable
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from the TV-VAVB3-E2.
Notification Class
In a typical i-Vu® system, the Notification Class is 1; however, if needed, you can
associate a different notification class with the alarm. See Notification Classes
(page 77) to set up alarm delivery options for a specific Notification Class.
Specific Events
On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following BACnet
alarms:
Specific alarms:
• Flow Control Alarm
• Reheat Valve Alarm
NOTE To set up alarm actions for controller generated alarms, see Alarms in i-Vu® Help.
Controller Generated Alarm
Description
Short message shown on the i-Vu® Alarms page or in an alarm action when this
type of alarm is generated.
Events
Alarm Category and Alarm
Template
See Alarms in i-Vu® Help.
Enable
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from this controller.
Notification Class
Do not change this field.