Adjusting the TV-VAVB3-E2 driver properties
TruVu™ VAVB3-E2 CARRIER CORPORATION ©2022
Installation and Start-up Guide All rights reserved
85
Once all changes are accepted, after applying changes this fields shows
success/fail statuses.
Address selection successful. It may take a few seconds
to updates in the status table. Please refresh the page to
see the updated status table.
This string appears after accepting the changes and
before success/fail messages are appeared. This
message may not appear all the time due to data refresh
rate.
Invalid serial number
format
A serial number that was entered manually has an
invalid format. Correct format example: 01647-20212-
250-160
Serial number format is valid, but the device with the
number cannot be located.
If the New Device Address is a duplicate, select an
unused address from the drop-down list. To update the
table, click Accept after every change.
When a device that does not have an address is found
on the bus, an unused address in automatically
assigned.
You can select a different address in the New Device
Address field, if needed.
To resolve duplicate addresses on Act Net bus
When devices display the error Duplicate Address on the network, you can use either of the following methods to
resolve the problem.
• Method 1: Using the Act Net Bus Configuration table
1. For each duplicate device, enter the Serial Number, which you can find on a sticker on the device.
2. Select a New Device Address from the drop-down list.
3. Click Accept.
4. Verify that there are no longer any Duplicate Address on the network errors.
• Method 2: Reinstalling the devices
1. Remove all duplicate devices from the bus.
2. Connect one of the removed devices and wait for the Act Net Bus Status table to update.
3. Chose a unique address for the new device and click Accept. Wait until the operation is successful.
4. Repeat the steps 2 and 3 for the remainder of the removed devices.
5. Verify that there are no longer Duplicate Address on the network errors.
To Next Page
Loading...
