Carrier TruVu VAVB3-E2 - Page 98

To set up the controller through the Comm/Service ports
TruVu™ VAVB3-E2 CARRIER CORPORATION ©2022
Installation and Start-up Guide All rights reserved
92
Local Devices table
Select
Check to select devices for:
• Changing the Mode
• Resolving a Mismatch
• Auto-assigning an IP Address
NOTE You cannot select devices with a lock symbol.
MAC
Ethernet MAC address of device
Serial#
The discovered devices are in order by serial number.
NOTE To change how the rows are sorted, click a different column heading.
Mode
To change the Mode:
1 Select the devices you want to change.
2 Select one of the following IP addressing modes:
○ Default IP - Devices with rotary switches that are used when
autogenerating the address (if applicable)
○ Custom Static - A permanent IP addresses which does not change
and is usually obtained from the network administrator
○ NOTE Selecting this automatically sets the device's subnet and
default gateway to match the connected controller.
○ DHCP - Allows the DHCP server to automatically assign an IP
address
3 Click the Set button.
Address
Displays the IP address of the device, if assigned. You can edit the address only
if the device is set to Custom Static.
To auto-assign multiple sequential addresses, select the devices, enter the
beginning address, and click Assign.
Location
You can describe the location of the device or any other helpful information.
Mismatch
A Mismatch occurs when the connected controller's mode is set to Custom
Static and a discovered device's subnet and default gateway do not match the
connected controller. The incorrect addresses are shown with SN for subnet
and GW for default gateway.
To resolve a mismatch, select the device(s) by clicking the Select checkbox and
then clicking the Resolve button. The subnet mask and default gateway
addresses of the selected devices change to match the connected controller.
Status
The following are the results of changing Mode, Address, Location, or pressing
Blink:
• Success - Successful operation
• No Response - Device is not communicating
• Device Locked - Device must be unlocked before you can make any
changes using the Local Devices table. You can unlock the TV-VAVB3-E2 by
pressing the DSC button on the device or by using the i-Vu® application.
(See instructions above.)
NOTE The status of a device changes to locked 24 hours after unlocking it.
• Failure - A conflict between the device and the information entered