SECTION 82 - LOADER 11
5. LOADER REMOVAL
Remove the loader bucket (see procedure described
previously).
Fully retract bucket cylinders and raise arm until lift
cylinder pivots can be seen above engine guard.
Place a suitable stand under the end of the arm to
take the weight.
Switch off the engine and relieve hydraulic pressure.
Remove the safety rings (2) and the pins and then
drive out the pins (1). Lower the lift cylinders carefully
onto the chassis.
Remove the snap rings (3) and drive out the pins (4).
Lower the arms onto the lift cylinders.
Disconnect and cap the lift cylinder hoses (5) at the
top of the loader arm on each side of the machine
and disconnect the return to dig sensor cable (7) on
the right hand side. If the 4x1 bucket is fitted discon-
nect and cap hose (6) on each side of the loader.
To Next Page
Loading...
