52 SECTION 27 - REAR AXLE
Position the axle on supports fitted to hold either the
central body or the axle-beam, even after their dis-
junction, or secure the three disjointed groups to a
lifting device with ropes or belts.
Unscrew the screws (2) to disassemble the axle
beam trumpet (1).
Remove the axle beam trumpet (1).
SWARNING
Once the axle beam trumpet has been removed, the
brake disks are free.
Remove the O-ring (4).
Remove the disks (9) and the intermediate disks
(10).
Remove the gear (8), the remaining brake disk and
the brake counterdisc (15).
Secure the brake flange (7) to a hoist with ropes or
safety belts.
Unscrew the upper screw (5) and the lower screw
(6). Remove the flange (7) from the central body, to-
gether with the bevel gear backlash-adjusting ring
nut.
SDANGER
This operation frees the differential box, that acci-
dentally could fall.
F28033
2 1
F28034
4
1
F28035
8
9
10
15
F28036
5 6
7
To Next Page
Loading...
