SECTION 27 - REAR AXLE 55
Assemble the new O-rings (4) and (19).
Assemble and tighten the upper screw (5) and the
lower screw (6) fastening the brake flange (7) to the
specified torque.
Assemble the brake disks (9), the intermediate
brake disks (10), the gear (8) and the brake counter-
disc (15).
Assemble the new O-ring (4).
In order to place the axle beam correctly, position
the half-beam (1) check the reference marks carried
out during disassembly.
NOTE: if new brake pads are installed, before as-
sembling, they should be dipped in the required oil.
F28037
4
19
F28043
7
5 6
F28035
8
9
10
15
F28034
4
1
To Next Page
Loading...
