4 QUICK START GUIDE
This Quick Start Guide gives you the minimum of information to allow you to get the router up
and running quickly. It assumes that the 6401 Rugged Router is running default configuration.
4.1.1 EQUIPMENT REQUIRED
PC - with web browser and an IP address within the subnet of 192.168.1.xx (where xx is any
address in the range apart from 1, which is the routers default address) use a subnet with a net mask
of 255.255.255.0 or /24.
Standard Ethernet cable – straight or crossover (The Case 6401 router will auto-detect)
Login On the PC use the web browser to connect to IP 192.168.1.1
You should see the following screen
Note: If you’re not able to obtain the logon screen try other Ethernet ports. If none of the Ethernet
ports display the Logon screen you may find the router has been configured with a different IP
Address. To ensure you have a connection to the port of the 6401 ‘Ping’ the routers default IP
address of 192.168.1.1. If no reply is received then use the reset switch on the rear of the router to
‘default’ the router back to its default settings.
On being asked for a login and password use admin (or support) for both entries
Having logged on the following page will displayed
On the left side select Advanced Setup to enter the configuration menu options.
Device Info
Advanced SetUp
Diagnostics
Management
6401 Rugged Router
Board ID 96328avng
Build timestamp 120217_1616
Software Version 4.06L.03
Bootloader (CFE) version 4.06L.03
DSL PHY and Driver Version A2pD035g.d23K
Line Rate- Upstream Kbps 2048
Line rate – Downstream (Kbps) 24,000,000
LAN IPv4 Address 192.168.1.1
Default gateway 192.168.1.200
Primary DNS Server 192.168.1.50
Secondary DNS Server 192.168.1.60
Device Info
This information reflects the current status of your WAN connection
To Next Page
Loading...
