Case Communications 6401 Rugged ADSL Router Manual – Rev 1.5
SECTION 5 – ADVANCED CONFIGURATION Page 5.39
5.8.5. CONFIGURING QOS CLASSIFICATION
This screen creates a traffic class rule to classify the upstream traffic, assign queue which defines the
precedence and the interface and optionally overwrite the IP header DSCP byte.
A rule consists of a class name and at least one condition below. All of the specified conditions in
this classification rule must be satisfied for the rule to take effect. Click 'Apply/Save' to save and
activate the rule. A rule consists of a class name and at least one condition below. All of the specified
conditions in this classification rule must be satisfied for the rule to take effect.
The Table below shows the Class Interfaces and where they may be used.
Classification Queue (assuming
Queues for all Ethernet ports are set)
IP, ARP, IPv6, PPPoE_DISC,
PPPoE_SES, 8865, 8866 or 8021Q
eth0, eth1, eth2, eth3, eth4 or ATM
eth0, eth1, eth2, eth3 or eth4
eth0, eth1, eth2, eth3, eth4 or ATM
IP, ARP, IPv6, PPPoE_DISC,
PPPoE_SES, 8865, 8866 or 8021Q
eth1, eth2, eth3, eth4 or ATM
IP, ARP, IPv6, PPPoE_DISC,
PPPoE_SES, 8865, 8866 or 8021Q
eth0, eth2, eth3, eth4 or ATM
IP, ARP, IPv6, PPPoE_DISC,
PPPoE_SES, 8865, 8866 or 8021Q
eth0, eth1, eth3, eth4 or ATM
IP, ARP, IPv6, PPPoE_DISC,
PPPoE_SES, 8865, 8866 or 8021Q
eth0, eth1, eth2, eth4 or ATM
IP, ARP, IPv6, PPPoE_DISC,
PPPoE_SES, 8865, 8866 or 8021Q
eth0, eth1, eth2, eth3 or ATM
eth0, eth1, eth2, eth3 or eth4
QoS Classification Setup -- A maximum 32 entries can be configured..
The screen that will be displayed will depend on which options are set. Therefore we have provided a
number of tables which show the options available. However there are too many combinations to
include all within this menu.
Specify Classification Criteria
Specify Classification Results
To Next Page
Loading...
