Case 6401 - Wan Services

Case Communications 6401 Rugged ADSL Router Manual – Rev 1.5
SECTION 5 – ADVANCED CONFIGURATION Page 5.7
5.2 WAN SERVICES
5.2.1 INTRODUCTION
ADVANCED SETUP >WAN SERVICE
Having configured the layer 2 interfaces we now configure the Wide Area Network Interfaces from
these menus. The configuration options are explained at the end of this section.
5.2.2 WAN SERVICE OPTIONS
The Layer 2 Configuration you have configured determines which WAN Services can be selected.
PPPoA – Point to Point Over ATM Only
IPoA – IP Over ATM
EOA WAN Options
Select WAN Service Type
 PPP over Ethernet (PPPoE)
 IP Over Ethernet
 Bridging
Ethernet-
 IPoE
 PPPoE
The table below shows which services can be configured with which layer two services;
Layer Two Service
WAN Service
EoA
PPPoA
IPoA
Ethernet
PPP Over ATM (PPPoA)
No
Yes
No
No
PPP over Ethernet (PPPoE)
Yes
No
No
Yes
IP over ATM
No
No
Yes
No
IP Over Ethernet (IPoE)
Yes
No
No
Yes
Bridging
Yes
No
No
No
Having selected the WAN service then the sub services also provide different options, as shown
below.
WAN Service Options
PPPoA
PPPoE
IPoA
IPoE
Bridging
NAT
Yes
Yes
Yes
Yes
N / A
Full cone NAT (enable/disable)
Yes
Yes
No
Yes
N / A
Dial on demand (idle timer)
Yes
Yes
No
No
N / A
Use PPP with IP Extension
Yes
Yes
No
No
N / A
Use Static IPv4 Address
Yes
Yes
Yes
Yes
N / A
Enable PPP debug Mode
Yes
Yes
No
No
N / A
Bridge PPPoE Frames between
WAN and Local ports
No
Yes
No
No
N / A
Enable IGMP Multicast Proxy
Yes
Yes
Yes
IGMP
N / A
Firewall
Yes
Yes
Yes
Yes
Disabled
Quality of Service
Yes
Yes
Yes
Yes