OPERATION & MAINTENANCE MANUAL STE35SR
Unloading
1. Load and unload on firm level ground only.
Maintain a safe distance from the edge of a
road.
2. Apply the trailer brakes securely, then put
blocks (1) under the tires to prevent the trailer
from moving.
Set left and right ramps (2) parallel to each
other and equally spaced to the left and right of
center (3) of the trailer. Make angle of
installation (4) a maximum of 15°. If the ramps
bend a large amount under the weight of the
machine, put blocks under the ramps to prevent them from bending.
3. Remove the chains and wire ropes fastening the machine.
4. Start the engine. Warm the engine up fully.
5. Turn the travel speed selector switch to low
speed travel.
6. Set the lock lever to FREE position.
7. Operate the fuel control dial to (A) to set the engine speed to low idling.
8. Raise the blade.
9. Raise the work equipment, pull in the arm
under the boom, and rise to blade, then move
the machine slowly. When the machine is
horizontal on top of the rear wheels of the trailer,
stop the machine. When on the ramps, operate
only the travel lever. Do not operate any other
lever.
To Next Page
Loading...