OPERATION & MAINTENANCE MANUAL STE35SR
If the seat belt is worn or damaged or accidentally deformed, replace the seat belt.
If the seat belt needs cleaning, it must be:
Use neutral soap liquid.
Before the belt is rolled up, allow it to dry in the sufficiently stretched condition.
Fasten and unfasten the seat belt
1. Sitting in a seat on the seat, allow the operator back against the seat back of a chair, in order
to work.
2. Hold grip and pull the belt out from wind-in device (1), check that the belt is not twisted, then
insert tongue (1) into buckle (2) securely.
3. Remove the seat belt, should carry handle with front end, to remove your seat belt.
REMARK
Adjust the fixed card buckle the length of the side, make against the body and avoid kink belt.
Operations before Starting Engine
When starting the engine, check that the lock lever is securely at the LOCK position.
If the lock lever is not locked securely and the control levers or control pedal are touched
when the engine is started, the machine may move unexpectedly, and this may lead to
serious personal injury.
When standing up from the seat, be sure to set the lock lever at the LOCK position,
regardless of whether the engine is running.
1. Confirm the battery cut-off switch in position I (electrify).
2. Check if the lock lever is at the LOCK position.
NOTE
If lock lever is not at the LOCK position, do not starting
engine.
3. Check the position of each lever.
To Next Page
Loading...