OPERATION & MAINTENANCE MANUAL STE35SR
Check After Completion of the Job
Before shutting down the engine
Check the engine cooling water temperature and engine oil pressure with the machine monitor. If
the coolant temperature gauge is in the red range, allow it to cool until the indicator enters the
green range, then stop the engine. If the engine oil pressure monitor lights up, stop the engine
immediately.
Check after Shut off Engine
1. Walk around the machine and check the work equipment, machine exterior, and undercarriage,
also check for any leakage of oil or coolant. If any problems are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a
fire hazard.
4. Remove any mud affixed to the undercarriage.
Locking
Always lock the following places.
(1) Right cover
(2) Rear cover
To Next Page
Loading...