OPERATION & MAINTENANCE MANUAL STE35SR
IMPORTANCE
When the work equipment is retracted, take care that it does not interfere with the machine body
or ground.
4. Operate the bucket and the arm in turn fully for 5 minutes. (Left handle 1,2 and right
handle3,4).
5. After performing the warming-up operation, check and be sure all the gauges on machine
monitor and the caution lamps are in the following conditions:
Fuel level monitor in the green range;
Coolant temperature monitor in the green range;
No alarm icon is displayed in the central area of the interface.
6. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact
your CFG distributor.
7. Set lock lever slowly and securely to LOCK position, and make sure that the left and right
control levels are not operated for turning and operating devices.
Stopping the Engine
IMPORTANCE
If the engine is stopped abruptly, service life of component parts of the engine may be
considerably reduced. Do not stop the engine abruptly except in an emergency.
If the engine has overheated, do not try to stop it abruptly but run it at medium speed to allow it to
cool down gradually, and then stop it.
1. Run the engine at low idle speed for about 5 minutes to cool down gradually.
2. Turn the key in starting switch to the OFF position and stop the engine.
3. Remove the key from starting switch.
Check after Shut off Engine
1. Walk around the machine and check the work
equipment, machine exterior, and undercarriage,
also check for any leakage of oil or coolant. If any
problems are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and
debris. Clean out any paper and debris to avoid a
fire hazard.
4. Remove any mud affixed to the undercarriage.
To Next Page
Loading...