OPERATION & MAINTENANCE MANUAL STE35SR
Wear Parts List
(The parts in parentheses are to be replaced at the same time)
Item Part No. Part Name Q'ty
Replacement
frequency
Engine oil filter
60025-03-00007
Water filter element 1 Every 250 hours
Fuel filter
60025-78-00006
60025-78-00005
60025-78-00007
Hydraulic return filter
Hydraulic suction filter
Preloaded air filter
1
1
1
Every 1000 hours
Every 2000 hours
Every 2000 hours
Fuel filter
60025-03-00006
60025-03-00005
Fuel pre-filter element
Fuel oil fine filter
1
1
Every 500 hours
Guide cartridge
60070-84-00165
Guide cartridge 1
First 500 hours,
every 1000 hours
Air cleaner
60017-07-00005
60017-07-00004
Main element
Safety element
1
1
After six times
every1000 hours
Bucket
60025-63-00018
60025-63-00020
60025-63-00021
Tooth
Jump ring
pin
3
3
3
——
60025-63-00017
60025-63-00016
Left edge blade
right edge blade
1
1
——
Plow
60025-53-00005
Knife plate (welding) 1
——
Notice: Actual replacement frequency accord to Maintenance schedule.
Use the Recommended Fuel, Coolant and Lubricants
In order to maintain the reliability and durability of CFG products and their parts, please use
CFG pure oil. Please buy pure oil from CFG or CFG appointed agency to ensure the oil
quality.
Failure to use the recommended product can result in shortened life and excessive wear of
engines, drivetrains, cooling systems and other components.
Select and use the oils and grades recommended in the table below according to ambient
temperature.
Under 0 ℃ when you start the engine, even if the temperature has risen to more than 0 ℃
temperature, also be sure to use more than the recommended grade engine oil.
When refueling, the filter should be removed from the refueling port first, and then be cleaned
with clean diesel oil and put back to the refueling port before refueling.
The addition of oil and grease should meet the requirements, not too much or too little.
The appliance that refuels, water must be clean, store in the box that covers tightly after using
or cabinet.
When the discharge of oil will make the oil temperature preheating to 30 ~ 40 ℃ advisable
To Next Page
Loading...