CFG STE35SR - Machine Operations and Controls; Before Starting Engine

OPERATION & MAINTENANCE MANUAL STE35SR
54
Heating
1. Start engine.
2. Click on the main instrument of the machine to open the air conditioning system. will be
displayed when the air conditioning system is open, will be displayed when the air
conditioning system is closed.
3. Use the air volume adjustment switch to adjust the air volume according to the situation. The
air volume increase from gear1 to gear3.
4. After starting to blow hot air, turn the temperature regulating switch (1) clockwise to the end,
and turn the air volume regulating switch (3) clockwise to the 3
rd
gear (HIGH) position, which
is helpful to rapidly raise the temperature in the car.
5. When the cab temperature rises to a suitable temperature, the temperature adjusting knob (1)
and the air volume adjusting knob (3) can be adjusted to reset the temperature.
Remark: Start the air conditioning, due to the low temperature of the engine circulating water,
blowing the wind is not hot, the machine needs to work for a period of time to blow out
the hot air.
Machine Operations and Controls
Before Starting Engine
Walk-around checks
Before starting the engine, look around the machine and under the machine to check for loose
nuts or bolts, or leakage of oil, fuel, or coolant, and check the condition of the work equipment and
hydraulic system.
Check also for loose wiring, play, and accumulation of dust at places, which reach high
temperatures.
 Before inspection and maintenance, the rear engine cover, side door and right front cover
must be opened and fixed.
 Clean the flammable materials around the battery, engine muffler or other high-temperature
engine parts. Fuel or oil leakage can cause the machine to catch fire. Check carefully and
repair any abnormalities or contact the dealer.
During the inspection, if the machine is tilted, make it level before proceeding with the inspection.
Before starting the engine every day, check the following items in this section.
1. Check whether the working device, cylinder, connecting rod, hose is damaged, worn or have
gaps
Check the working device, cylinder, connecting rod or hose for cracks, excessive wear or
gaps. If any problem is found, repair it.
2. Remove dirt and debris from around the engine, battery, and radiator.
Check for dirt accumulated around the engine and radiator. Also check for flammable material
(dry leaves, twigs, etc.) around the battery, engine muffler, turbocharger, or other high
temperature engine parts. If any dirt or flammable materials are found, remove them.
3. Check for coolant and oil leakage around the engine.
Check for oil leakage from the engine and coolant leaks from the cooling system. If any
problem is found, repair it.
4. Check for oil leakage from hydraulic equipment, hydraulic tank, hoses, and joints
Check for oil leakage.
If any problem is found, repair the area where oil is leaking.
5. Check whether the grease pipeline leaks grease.
If any problem is found, repair it.
6. Check whether the monitor is damaged and whether the bolts are loose.