OPERATION & MAINTENANCE MANUAL STE35SR
Maintenance Information
Do not perform any inspection and maintenance operation that is not found in this manual.
Service Meter Reading
Check the service meter reading every day to see if the time has come for any necessary
maintenance to be performed.
Genuine Replacement Parts
Use CFG genuine parts specified in the Parts Book as replacement parts.
CFG Genuine Lubricants
Use CFG genuine oils and grease. Choose oils and grease with proper viscosities specified for
ambient temperature.
Fresh and Clean Lubricants
Use clean oil and grease. Also, keep the containers of the oil and grease clean. Keep foreign
materials away from oil and grease.
Check Drained Oil and Used Filter
After oil is changed or filters are replaced, check the old oil and filters for metal particles and
foreign materials. If large quantity of metal particles or foreign materials are found, always report to
the person in charge, and carry out suitable action.
Fuel Strainer
If your machine is equipped with a fuel strainer, do not remove it while fueling.
Welding Instructions
Cut off power. Wait for approx. one minute after turning off the engine starting switch key, and
then disconnect the negative (-) terminal of the battery.
Do not apply more than 200 V continuously.
Connect grounding cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is
connected near instruments, connectors, etc., the instruments may malfunction.
If a seal or bearing happens to come between the part being welded and grounding point,
change the grounding point to avoid such parts.
NOTE
Do not use the area around the work equipment pins or the hydraulic cylinders as the
grounding point.
Do not Drop Things Inside Machine
When opening inspection windows or the oil filler port of the tank to carry out inspection, be
careful not to drop nuts, bolts or tools inside the machine.
If such things are dropped inside the machine, it may cause damage and/or malfunction of the
machine, and will lead to failure. If you drop anything inside the machine, always remove it
immediately.
Do not put unnecessary things in your pockets. Carry only things which are necessary for
inspection.
To Next Page
Loading...