OPERATION & MAINTENANCE MANUAL STE35SR
The monitor should be undamaged. If an
abnormality is found, replace the parts. Remove
foreign objects on the surface.
7. Seat belt and mounting clamps
Check for damage or wear to the seat belt and
mounting clamps. If there is any damage, replace
with new parts.
8. Check bucket with hook (if equipped) for damage.
Check for damage to the hook, guide, and hook
mount. If any problem is found, contact your CFG
distributor for repairs.
Checks before Starting
Always check the items in this section before starting the engine each day.
Coolant Level: Check or Add
Do not open the radiator cap unless necessary. Wait for the engine to cool down before
checking the coolant in the sub-tank.
Immediately after the engine is stopped, the coolant is at a high temperature and the radiator
is under high internal pressure.
If the cap is removed to check the coolant level in this condition, there is a hazard of burns.
Wait for the temperature to go down, then turn the cap slowly to release the pressure before
removing it.
Check and add the machine at the level of the place.
Check the coolant level before starting every day.
1. Open the rear hood (1), and ensure that the
support rod (2) falls into the slot to lock, so as to
avoid the side door collision.
2. Check the coolant level of sub-tank (3).
If the coolant level is between the FULL and
LOW marks means normal.
If the coolant level is low, add coolant to the
FULL level through the filler port of sub-tank (3).
If the sub-tank (3) is empty, there is probably
leakage of coolant. After inspecting, repair any
problem immediately.
3. At the same time of press the radiator cap (4),
unscrew the cove until it comes into contact with the brake and remove the cover. Check the
coolant level of the radiator, if lacking of coolant, then add coolant and check whether there is
any leakage on line.
4. Check the rubber hoses and pipe clamps for damage, cracks and looseness, and tighten
them immediately if they are loose. If damaged, the hose or pipe clamp must be replaced
immediately, otherwise the engine is not allowed to start.
Pipe clamp tightening torque of 5.9±0.49N·m(60±5kg·cm)
Oil Level in Engine: Check or Add
Parts and oil are at high temperature immediately after the engine is stopped and may cause
serious burns. Wait for the oil temperature to go down before performing this operation.
To Next Page
Loading...