OPERATION & MAINTENANCE MANUAL STE35SR
Notice
For details of the removal or installation operation, please consult your CFG distributor.
For details of disassemble and installation operations, contact the dealer.
Attachment Installation
When long or heavy work equipment is installed,
remember the following precautions.
Before starting operations, move the machine to a
safe place and carry out a test operation to make
sure that you fully understand the movement,
center of gravity, and working range of the
machine.
Do not swing the work equipment if the machine is
at an angle. If the work equipment is swung with
the machine at an angle, there is danger that the
machine will tip over.
Always maintain a safe distance from obstacles in
the surrounding area when operating. If long work
equipment is installed, the working range
becomes larger.
The swing overrun (the distance the work
equipment moves before completely stopping
after the swing brake is applied) will be greater.
There is danger of hitting objects if the swing
overrun is miscalculated, so allow extra space to
the swing position when swinging.
The hydraulic drift of the work equipment (the
amount of the work equipment moves down under
its own weight when it is stopped in a raised
position) also becomes greater. Do not stop the
work equipment in a raised position; always lower
it to the ground.
Do not swing, lower, or stop the work equipment
suddenly. There is danger that the machine may
tip over.
Do not suddenly extend or retract the boom
cylinder. The shock may cause the machine to tip
over.
To Next Page
Loading...