OPERATION & MAINTENANCE MANUAL STE35SR
Coolant level in cooling system - check/fill
Engine oil level - check/fill
Fuel level - check/fill
Hydraulic oil level - check/fill
Fuel pre-filter - check/drain
Electric wiring - check
Alternator belt tension – check/adjust
Every 100 hours of maintenance
Engine oil and oil filter -- check/fill
Maintenance every 250 hours
Engine oil and oil filter element - replacement
Grease for slewing bearings and pinion gear - fill
Radiator and condenser fins - check/clean
Gear oil level of walking reducer - check
Fan belt - check/adjust
Lock core - maintenance/lubrication
Hinge - maintenance/lubrication
Maintenance every 500 hours
Fuel fine filter element - replacement
The guide cartridge - replacement
Gear oil for walking gear reducer - replacement
Fuel pre-filter element - replacement
Maintenance every 250 hours shall be performed simultaneously
Maintenance per 1000 hours
Hydraulic oil return filter element - replacement
Gear oil for walking reducer - replacement
The guide cartridge - replacement
Air filter main filter element and safety filter element - replacement
Grease for slewing support gear - inspection
Maintenance should be performed at the same time every 250 and 500 hours
Every 2000 hours of maintenance
Hydraulic oil - change
Suction filter element of hydraulic oil tank – change
Preloaded air filter (hydraulic oil tank breathing valve) - change
Maintenance should be performed at the same time every 250, 500 and 1000 hours
Maintenance every 3,000 hours
Grease in oil pool of rotary device – replacement
To Next Page
Loading...