OPERATION & MAINTENANCE MANUAL STE35SR
Hydraulic Oil Replace
After the engine is stopped, all parts and hydraulic oil are still at high temperature, so do not
immediately replace the hydraulic oil and filter element, or it will cause burns. To wait for the
parts and hydraulic oil temperature down after the start of maintenance.。
Oil may spout when the cap of the suction port is removed. Press the top button of the
breather valve to release pressure inside the tank before removing the cap.
Oil receptacles shall have a capacity of at least 32L.
Fuel capacity: about 32L.
Prepare 10mm square.
Prepare new preloaded air filter 1 piece.
1.Rotary machine makes the oil discharge screw
plug under the hydraulic oil tank located in the middle
of the left and right tracks.
2.Retrieve the oil cylinder of the bucket rod and bucket, lower the moving arm and dig the bucket
tooth into the ground. And lower the bulldozer to the
ground.
3.After flame out, turn the electric lock to the ON
position and put the safety lock lever in the position○
F
. Shake the control handle left and right to
release the pressure inside the system. After completion, turn the electric lock to the OFF position
and put the safety lock lever in the locked position○
L
.
To Next Page
Loading...