OPERATION & MAINTENANCE MANUAL STE35SR
Emergency treatment: battery burst, a large number of spills, sulfate operator should
immediately flush sulfuric acid splash down; When necessary, will be ablation of sulfate
personnel immediately to a hospital treatment.
Additional Electric Battery
Before cars started, the car with electric start time is too long and abnormal use, because of
leakage and long car stops, the vehicle or the vehicle charging generator failure, the battery can't
normal charging battery loss caused by electricity, battery electric eye blackened, even can't start
the car. The battery need to supplement by electricity.
Check that the open circuit voltage of the battery terminal is lower than 12.45V, and the battery
should be supplemented immediately.
When charging the battery we must know
Wearing glasses.
Maintain environmental ventilation when charging, charging under normal temperature.
No smoking when charging, and to avoid the introduction of the flame.
After charging connection, first connect the positive attachment; Take out stitches before
charging, disconnect the cathode attachment first.
Battery supplement electricity at action part “Battery Discharges and Charges”.
Staring Engine with Booster Cables
If any mistake is made in the method of connecting the booster cables, it may cause the battery to
explode, so always do as follows.
When starting with a booster cable, carry out the starting operation with two workers (one
worker sitting in the operator's seat and the other working with the battery).
When starting from another machine, do not
allow the two machines to touch.
When connecting the booster cables, turn the
starting switch OFF for both the normal
machine and problem machine. There is a
hazard that the machine will move when the
power is connected.
Be sure to connect the positive (+) cable first
when installing the booster cables. Disconnect
the negative (-) cable (ground side) first when
removing them.
When connecting the auxiliary cable, set the
start switch of the faulty machine, the battery
disconnect switch and the start switch of the
normal machine to the OFF (closed) position.
For details, please refer to the item "Battery
disconnect switch". When the power is
connected, the machine may start and cause
danger.
When removing the booster cables, be careful
not to let the booster cable clips touch each
other or to let the clips touch the machine.
Always wear safety goggles and rubber gloves
when starting the engine with booster cables.
When connecting a normal machine to a problem machine with booster cables, always use a
normal machine with the same battery voltage as the problem machine.
For details of the starting procedure when using booster cables, see “Starting Engine with
Booster Cables” in the OPERATION section.
To Next Page
Loading...