OPERATION & MAINTENANCE MANUAL STE35SR
When loosening grease drain plug (1) to loosen
the track tension, never loosen it more than one
turn. Loosen the grease drain plug slowly.
Do not place the face, hands, feet or other parts
of the body close to the grease drain plug①.
Do not disassemble recoil springs
Never attempt to disassemble the recoils spring
assembly. It contains a spring under high pressure
which serves as a shock absorber for the idler. If it is
disassembled by mistake, the spring will fly out and
cause serious injury. When it becomes necessary to
disassemble it, ask your CFG distributor to do the work.
High pressure oil
Hydraulic system is stressful. When inspecting or replacing the pipe or hose, be sure to check the
pressure inside the hydraulic circuit has been released, otherwise, it will cause major accidents.
So do as the following provisions:
Release the pressure. When the hydraulic system has pressure, don't inspect and replace the
operation.
If there are any pipe or hose leaks, or its
surrounding area is wet, check whether the pipe
or hose burst, and whether the hose expansion.
Wear protective equipment such as goggles and
leather gloves, when check.
High pressure oil from the hole leakage will
penetrate into the skin, if it contact with eyes
direction, you will be at the risk of blindness. If
skin or eyes was hit by a high pressure oil, Rinse
with clean water and contact the doctor
immediately.
Operation of the pipeline and high pressure hose
If high pressure hose or pipeline leak, it will cause a fire or the operation failure, lead to major
accidents. If you find the hose leaks or the installation of piping parts loose, stop working and
tighten the installation site to specified torque again. If there is any damage on hose or piping or
deformation, contact with the CFG distributor.
The hose should be replaced, if existence as follows:
Hose damage, pipe joint deformation, o-ring
damage.
Cladding torn or broken, or reinforcing steel wire
exposed.
Clad inflation in some places.
Movable part of the hose distorted or signs of a
crush.
Cladding with foreign matter.
Waste materials
To prevent pollution, pay careful attention to the method of disposing of waste materials.
Always put oil drained from your machine in containers. Never drain oil directly onto the
ground or dump into the sewage system, rivers, the sea, or lakes.
Obey appropriate laws and regulations when disposing of harmful objects such as oil, fuel,
coolant, solvent, filters, and batteries.
To Next Page
Loading...