OPERATION & MAINTENANCE MANUAL STE35SR
Bucket operation
Operate the right control lever to the right (3) or left
(4) to operate the bucket.
Blade operation
Move the blade lever forward or backward to
operate the blade.
REMARK
When the engine stops, if necessary, lower the
working device to the ground or release the residual
pressure in the hydraulic circuit and do this as
follows.
1. Turn the key to the ON position, lift the safety
lock lever to position.
2. Operate the required action, at this time the
working device will operate in accordance with
the control handle slowly. Move the handle
back and forth a few times to release the
internal pressure fully.
3. Turn the key to the OFF position, put down the
safety lock lever.
REMARK
The control action requires the ability to
descend under the action of its own gravity.
Generally, the action can be able to control including a bucket arm eversion, boom down,
dozer down.
When carrying out hydraulic system maintenance (joint hose disassembly and replacement, etc.)
must release pressure, otherwise it will cause serious injury.
To Next Page
Loading...