Call Termination
1. To end a call in progress, momentarily press the
UConnect™ button.
Only the active call/s will be terminated and if there is a
call on hold, it will become the new active call.
2. If the active call is terminated by the far end, a call on
hold may not become active automatically. This is cell
phone dependent.
3. To bring the call back from hold, press and hold the
UConnect™ button until you hear a single beep.
Redial
1. Press the UConnect™ hard-key to begin.
2. Wait for the beep.
3. Say REDIAL.
4. The UConnect™ system will call the last number that
was dialed on your cellular phone.
NOTE: This may not be the last number dialed from the
UConnect™ system.
Call Continuation
Call continuation is progression of a phone call on
UConnect™ system after the vehicle ignition key has
been switched to off. Call continuation functionality
available on the vehicle can be any one of three types:
1. After ignition key is switched off, a call can continue
on the UConnect™ system either until the call ends or
until the vehicle battery condition dictates cessation of
the call on the UConnect™ system and transfer of the call
to the mobile phone.
110 NAVIGATION
To Next Page
Loading...
