Commands
The Voice Recognition understands two types of com-
mands. Global commands are available at all times. Local
commands are available if the supported radio mode is
active.
Changing the Volume
1. Start a dialogue by pressing the VR hard-key.
2. Say a command (e.g., HELP).
3. Use the ON/OFF VOLUME rotary knob to adjust the
volume to a comfortable level while the voice recognition
system is speaking.
Main Menu
Start a dialogue by pressing the VR hard-key.
You may say MAIN MENU to switch to the SDS main
menu.
In this mode you can say the following commands:
•
RADIO (to switch to the radio mode)
•
HARD DRIVE (to switch to the HDD mode)
•
DISC (to switch to the disc mode)
•
VES (to switch to the VES mode)
•
MEMO (to switch to the memo recorder)
•
NAVIGATION (to switch to the navigation mode)
•
SYSTEM SETUP (to display the system setup menu)
Radio Menu
You may say RADIO to switch to AM, FM, or SAT.
Say RADIO MENU.
•
In this mode you may say the following commands:
•
RADIO AM (to switch to the AM band)
NAVIGATION 91
1
To Next Page
Loading...
Need help?
General
