INTRODUCTION
SECTION 1 IDENTIFICATION
SECTION 2 INSTALLATION
UNLOADING 2-1
LIFTING AND MOVING 2-1
FOUNDATION 2-2
ERECTION - ASSEMBLED MACHINES 2-2
ERECTION - DESASSEMBLED MACHINES 2-3
CLEANING 2-6
LEVELING 2-6
HYDRAULIC RESERVOIR 2-7
LUBRICATION 2-7
ELECTRICAL CONNECTION 2-7
CNC PLATE GAGE (Optional) 2-8
SECTION 3 SAFETY
SAFETY RECOMMENDATIONS 3-1
SAFE OPERATION 3-1
OPERATING RULES 3-2
INSTALLING / REMOVING TOOLING GUIDELINES 3-3
SAFETY SIGNS 3-3
SAFETY GUIDELINES 3-5
SAFETY MAINTENANCE CHECK 3-5
SECTION 4 SPECIFICATIONS
SPECIFICATIONS 4-1
DEFINITION OF TERMS 4-3
CAPACITIES 4-4
PUNCHING CAPACITY 4-4
STRIPPING CAPACITY 4-5
ECCENTRIC LOAD CAPACITY (F-B) 4-5
OFF-CENTER LOAD CAPACITY (L-R) 4-6
SECTION 5 SET-UP AND USE
PRESS BRAKE TOOLING 5-1
TYPES OF DIES 5-1
TOOL INSTALLATION 5-2
GAGING - OPTIONAL BACKGAGES 5-3
CAPACITY 5-5
GAGE ASSEMBLY 5-4
ADJUST GAGE FINGER POSITION 5-5
PROGRAM GAGE POSITION(S) 5-7
WORK SUPPORTS 5-7
OPERATING TECHNIQUES 5-8
TOOLING AND SETUP 5-8
RUNNING 5-8
GAGES 5-8
REMOVING TOOLING 5-8
SECTION 6 MACHINE CONTROLS
MACHINE CONTROL STATIONS 6-1
CONTROLS 6-1
FM CONTROL STATION 6-2
PALMBUTTON OPERATOR STATION 6-4
FOOTSWITCH 6-5
ELECTRICAL ENCLOSURE 6-5
FM HYDRAULIC PRESS BRAKE CONTENTS
EM-446 (N-08/99)
To Next Page
Loading...
