CipherLab 8000 User Manual

143
Appendix III LR/ELR Laser Scan Engine
Addon 2 / Addon 5 Refer to UPC/EAN Addon setting.
Convert to UPC-A The UPC-E1 barcode will be expanded into UPC-A, and the
next processing will follow the settings configured for
UPC-A.
No
UCC Coupon Extended Code Disable
Read UPC-A barcodes starting with digit "5", EAN-13 barcodes starting with digits "99", and
UPC-A/GS1-128 Coupon Codes.
 UPC-A, EAN-13, and GS1-128 must be enabled first!
UPC/EAN Addon ---
Addon 2 / Addon 5 Decide whether to decode EAN-8, EAN-13, UPC-E0,
UPC-E1, UPC-A with addons.
 Ignore Addons
 Decode Only With Addons
 Decode With Addons (= Auto-discriminate)
Ignore...
Code 11 Enable
Verify Check Digit Decide whether to verify the check digit. If the check digit
is incorrect, the barcode will not be accepted.
 No verification
 One Check Digit
 Two Check Digits
No
Select Length
 Any Length
 One or two fixed lengths
 Range (1~55)
Any Length
Note: Code 11 is supported on Long Range Laser scan engine for 8300 only.
GS1 Formatting (8300 only) ---
GS1-128 (EAN128)
Decide whether to enable GS1 formatting for GS1-128.
Disable
GS1 DataBar
Omnidirectional
Decide whether to enable GS1 formatting for GS1 DataBar
Omnidirectional.
Disable
GS1 DataBar Limited
Decide whether to enable GS1 formatting for GS1 DataBar
Limited.
Disable
GS1 DataBar Expanded
Decide whether to enable GS1 formatting for GS1 DataBar
Expanded.
Disable
Field Separator
Specify the field separator.
No
Application ID Mark
Specify the application ID mark character.
No

CipherLab 8000 Specifications

General

Operating System	Proprietary
Humidity	5% to 95% non-condensing
Barcode Scanner	Laser
Connectivity	RS-232
Ports	RS-232
Weight (Extended)	280g (with battery)
Storage Temperature	-20°C to 60°C
Drop Specification	1.2m