145
Chapte
4 Radios
CONFIGURING CONNECTION SETTINGS
Change the connection preference for a specific service by enabling (selecting Y) or
disabling (selecting N) the last two columns, Last Connection and Auto Inquiry.
If you select Y for Last Connection or Auto Inquiry, “Allow to resume last service”
and “Auto Inquiry” must be enabled on the General tab. On the other hand, the
connection settings will be ignored if the two settings are disabled on the General tab.
Options
Description
Last Connection Decide whether to re-connect to the previous services when the mobile
computer reboots or goes through a Bluetooth power cycle. Configurable
services include:
Headset/Handsfree
HID
PAN
SPP
Auto Inquiry Based on the settings for “Last Connection”, tap this field to decide
whether to detect a device after a specific time interval.
For Headset/Handsfree, HID, and PAN services, the value of “Auto
Inquiry” will automatically follow the settings for “Last Connection”.
For SPP service, when “Last Connection” is enabled (= “Y”), the value of
“Auto Inquiry” can be manually set to “Y” or “N”.
If Auto Inquiry is enabled, tap the General Tab to set the interval for
the mobile computer to perform an inquiry.
Note: To save the battery power of your mobile computer, we suggest you disable “Auto
Inquiry” unless necessary.
To Next Page
Loading...
