Cisco 1240 - Page 10

Contents
x
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
CHAPTER 13 Installing External Non-Cisco Modules 13-1
External Non-Cisco Module Support 13-1
Caveats 13-1
External Non-Cisco Module Requirements 13-2
Cable Requirements 13-2
Online Installation and Removal 13-2
Power 13-2
Before Installing 13-3
Prepare the Installation Site 13-3
Read the Safety Information 13-3
Preventing Electrostatic Discharge Damage 13-3
Cabling Guidelines 13-3
Install an External Non-Cisco Module 13-4
Tools and Materials You Supply 13-4
Open and Close the Router Door 13-4
Connect the Module to the Chassis 13-4
Installation Options 13-5
Cabling Instructions 13-6
External Cabling 13-7
Internal Cabling 13-8
Connect to the Network 13-8
Connect to Power 13-9
Related Information 13-10
CHAPTER 14 Router LED Locations and States 14-1
LED Locations and State Descriptions 14-2
SYS LED—System Status 14-2
Alarm and Network Connection LEDs 14-3
ALM LEDs—Alarm Status 14-3
ETH LEDs—Fast Ethernet Interface Status 14-4
SFP LEDs—Combo Port and SFP Port Status 14-4
SYS and ACT LEDs—System Status 14-5
WiFi LED—WiFi Link State 14-5
GPS LED—GPS Link State 14-5
Battery Backup Unit LED 14-6
SD Flash Memory Module LED – SD Card Status 14-7
Related Commands 14-8
Displaying Router SYS LED Status Command 14-8
Cisco CG-OS show led Command 14-8