Cisco 1240 - Page 7

Contents
vii
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Installing Modules and Antennas 6-23
CHAPTER 7 Powering Off the Router 7-1
Verify Console or Terminal Access to the Router 7-1
Disable the Router BBU at the CLI 7-2
Disconnect Router AC Power 7-2
Disable the BBU by Disconnecting the BBU Harness Cable 7-3
Check SYS LED 7-4
CHAPTER 8 Unmounting the Router 8-1
Materials and Tools You Supply 8-1
Unmounting Instructions 8-1
Transporting the Router 8-3
CHAPTER 9 Connected Grid Modules 9-1
Installing or Replacing Modules 9-1
Installing Modules in the Router 9-1
Installation Steps for Specific Modules 9-1
Preparing to Install Modules 9-1
Installation Warning Statements 2
Installing and Removing Modules 9-2
Referenced Installation Documents 9-3
Tools and Materials You Supply 9-3
Module Installation Locations 9-3
Installing a Module in an Offline Router 9-3
Installing a Module in an Online Router 9-5
Removing a Module from an Offline Router 9-5
Removing a Module from an Online Router 9-6
Module Documentation 9-6
CHAPTER 10 Antennas 10-1
Installing or Replacing Antennas 10-1
Lightning Arrestor 10-1
Cisco Connected Grid Modules 10-2
Antennas Overview 10-2
GPS Antenna 10-2
WiFi Antenna 10-3
Connected Grid Module Antennas 10-4