Cisco ASR 9000 Series - Page 100

PurposeCommand or Action
Ends the class map configuration.end-class-map
Example:
RP/0/RSP0/CPU0:router(config-cmap)# end-class-map
Step 4
Creates or modifies a policy map that can be attached
to one or more interfaces to specify a service policy and
enters the policy map configuration mode.
policy-map [ type qos ] policy-name
Example:
RP/0/RSP0/CPU0:router(config)# policy-map policy5
Step 5
Specifies the name of the class whose policy you want
to create or change.
class class-name
Example:
RP/0/RSP0/CPU0:router(config-pmap)# class class5
Step 6
Specifies the bandwidth allocated for a class belonging
to a policy map.
bandwidth {bandwidth [units] | percent value}
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# bandwidth
percent 13
Step 7
Returns the router to policy map configuration mode.exit
Example:
RP/0/RSP0/CPU0:router(config-pmap)# exit
Step 8
Ends the policy map configuration.end-policy-map
Example:
RP/0/RSP0/CPU0:router(config-pmap)# end-policy-map
Step 9
Configures an interface and enters the interface
configuration mode.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
TenGigabitEthernet 0/1/0/0.1
Step 10
Defines the encapsulation format as IEEE 802.1Q
(dot1q), and specifies the VLAN identifier.
encapsulation dot1qvlan-identifier
Example:
RP/0/RSP0/CPU0:router(config-if)# encapsulation dot1q
20
Step 11
Enters the satellite network virtualization (nV)
configuration submode.
nv
Example:
RP/0/RSP0/CPU0:router(config-subif)# nv
Step 12
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
90
Configuring QoS on the Satellite System
Offloading Service-policy on L2 Fabric Physical SFL