Cisco ASR 9000 Series System Configuration Guide

•
RSP1 on rack 0 is a non-DSC and the standby RSP for the rack.
•
RSP0 on rack 1 is a non-DSC and the standby RSP for the rack.
•
RSP1 on rack 1 is the backup-DSC and the active RSP for the rack.
The DSC role is used for tasks that only need to be completed once in the system, such as apply the
configuration or perform installation activities.
Note
The role of primary RSP is determined by the order the racks and the RSPs are booted.Note
Additional References
The following sections provide references to related documents.
Related Documents
Document TitleRelated Topic
Cisco IOS XR Master Commands ListCisco IOS XR master command reference
Cisco ASR 9000 Series Aggregation Services Router
Getting Started Guide
Satellite System software upgrade and downgrade on
Cisco IOS XR Software
Cisco ASR 9000 Series Aggregation Services Router
Interface and Hardware Component Command
Reference
Cisco IOS XR interface configuration commands
Cisco ASR 9000 Series Aggregation Services Router
Modular Quality of Service Configuration Guide
Satellite Qos configuration information for the Cisco
IOS XR software
Cisco ASR 9000 Series Aggregation Services Router
L2VPN and Ethernet Services Configuration Guide
Layer-2 and L2VPN features on the Satellite system
Cisco ASR 9000 Series Aggregation Services Router
MPLS Layer 3 VPN Configuration Guide
Layer-3 and L3VPN features on the Satellite system
Cisco ASR 9000 Series Aggregation Services Router
Multicast Configuration Guide
Multicast features on the Satellite system
Cisco ASR 9000 Series Aggregation Services Router
Broadband Network Gateway Configuration Guide
Broadband Network Gateway features on the Satellite
system
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
153
Configuring the nV Edge System on the Cisco ASR 9000 Series Router
Additional References

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English