Remote version: Compatible (latest version)
ROMMON: 126.0 (Latest)
FPGA: 1.13 (Latest)
IOS: 322.6 (Latest)
Configured satellite fabric links:
TenGigE0/0/0/1
--------------
Status: Satellite Ready
Remote ports: GigabitEthernet0/0/0-10
##Standby host:
RP/0/RSP1/CPU0:Router# show nv satellite status satellite 200
Satellite 200
-------------
Status: Connected (Stable)
Redundancy: Standby (Group: 10)
Type: asr9000v
MAC address: 8478.ac01.d2d8
IPv4 address: 192.1.1.200 (VRF: default)
Serial Number: CAT1708U0LV
Remote version: Compatible (latest version)
ROMMON: 126.0 (Latest)
FPGA: 1.13 (Latest)
IOS: 322.6 (Latest)
Configured satellite fabric links:
TenGigE0/3/0/6
--------------
Status: Satellite Ready
Remote ports: GigabitEthernet0/0/0-10
Simple Ring Topology
RP/0/RSP1/CPU0:Router# show nv satellite topology interface tenGigE 0/3/0/6
TenGigE0/3/0/6
--------------
Redundancy-Group: 10
Discovery status: Running
Satellites:
Satellite 100 (BVID 2002)
-------------------------
Received Serial Number: CAT1547B30S
MAC address: 4055.3957.5f50
Satellite fabric links:
TenGE/0/0/0 (Remote ID: 0x1):
Host (TenGigE0/3/0/6)
TenGE/0/0/3 (Remote ID: 0x4):
Sat 200 (TenGE/0/0/3 (Remote ID: 0x4))
Satellite 200 (BVID 2003)
-------------------------
Received Serial Number: CAT1708U0LV
MAC address: 8478.ac01.d2d8
Satellite fabric links:
TenGE/0/0/3 (Remote ID: 0x4):
Sat 100 (TenGE/0/0/3 (Remote ID: 0x4))
TenGE/0/0/0 (Remote ID: 0x1):
Remote port not yet identified
Monitoring the Satellite Protocol Status
To check the status of the satellite discovery protocol, use the show nv satellite protocol discovery command.
RP/0/RSP0/CPU0:router# show nv satellite protocol discovery brief
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
59
Configuring the Satellite Network Virtualization (nV) System
Monitoring the Satellite Protocol Status
To Next Page
Loading...
Need help?
General
