PurposeCommand or Action
Configures the remote satellite ports for the satellite
500.
remote-ports interface-type
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)#
remote-ports GigabitEthernet 0/0/9,5
Step 13
Specifies the satellite ID of the connected satellite in
the simple ring..
satellite <satellite id>
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)# satellite
600
Step 14
Configures the remote satellite ports for the satellite
600.
remote-ports interface-type
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)#
remote-ports GigabitEthernet 0/0/9,5
Step 15
Saves configuration changes.end or commit
Step 16
Example:
RP/0/0RSP0/CPU0:router(config)# end or
RP/0/0RSP0/CPU0:router(config)# commit
•
When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
- Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
- Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
- Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
•
Use the commit command to save the
configuration changes to the running
configuration file and remain within the
configuration session.
Auto-IP
The Auto IP feature improves the plug-and-play set up of an nV satellite system. With the Auto IP feature,
IP connectivity to the satellite is automatically provisioned. As a result:
•
The nV Satellite Loopback interface is created on the host
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
43
Configuring the Satellite Network Virtualization (nV) System
Configuring the Inter-Chassis Links and IP Connectivity