EasyManuals Logo
Home>Cisco>Network Router>ASR 9000 Series

Cisco ASR 9000 Series System Configuration Guide

Cisco ASR 9000 Series
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
PurposeCommand or Action
(Optional) Specifies the priority for the satellite on each
of the host. The host with the lower priority is preferred
as the active host. The default priority is 128.
host-priority <0-255>
Example:
RP/0/0RSP0/CPU0:router(config-redundancy-iccp-group)#
host-priority 128
Step 4
(Optional) Specifies the MAC address. Two hosts in
the same redundancy group will sync up the system
nv satellite system-mac <mac_address>
Example:
RP/0/0RSP0/CPU0:router(config-redundancy-iccp-group)#
nv satellite system-mac dcddc.dcdc.dcdc
Step 5
MAC address and satellite priority information. The
System MAC must be the same. If it is different, then
the Host with low chassis MAC gets priority. If the
system MAC is not configured, then it uses low host
chassis MAC as the system MAC.
The supported inter-chassis link interface types are
limited by the connectivity provided on the supported
interface interface-name
Example:
RP/0/0RSP0/CPU0:router(config)# interface
TenGigE0/2/1/0
Step 6
satellites. GigabitEthernet, TenGigE, and Bundle-Ether
interfaces are the only support ICL types.
(Optional) Configures the IPv4 point to point address.ipv4 point-to-point
Example:
RP/0/0RSP0/CPU0:router(config-if)# ipv4 point-to-point
Step 7
(Optional) Configures the IPv4 loopback address on
the interface.
ipv4 unnumbered loopback0
Example:
RP/0/0RSP0/CPU0:router(config-if)# interface
unnumbered loopback0
Step 8
Enters the nV satellite mode.nv
Example:
RP/0/0RSP0/CPU0:router(config-if)# nV
Step 9
Specifies the network type of ICPE inter-chassis link.satellite-fabric-link network
Example:
RP/0/0RSP0/CPU0:router(config-if-nV)#
satellite-fabric-link network
Step 10
Configures the ICCP redundancy group.redundancy iccp-group
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)# redundancy
iccp-group 2
Step 11
Specifies the satellite ID of the satellite.
satellite <satellite id>
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)# satellite
500
Step 12
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
42
Configuring the Satellite Network Virtualization (nV) System
Configuring the Inter-Chassis Links and IP Connectivity

Table of Contents

Other manuals for Cisco ASR 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 9000 Series and is the answer not in the manual?

Cisco ASR 9000 Series Specifications

General IconGeneral
BrandCisco
ModelASR 9000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals