end-policy-map
!
interface GigabitEthernet100/0/0/9
ipv4 address 10.1.1.1 255.255.255.0
nv
service-policy input my_policy
!
!
Prerequisites for QoS Offload Configuration
You must be in a user group associated with a task group that includes the proper task IDs. The command
reference guides include the task IDs required for each command. If you suspect user group assignment is
preventing you from using a command, contact your AAA administrator for assistance. Before configuring
the QoS offload feature, you must have these hardware and software installed in your chassis.
• Hardware—Cisco ASR 9000 Series Aggregation Services Routers with Cisco ASR 9000 Enhanced
Ethernet line cards as the location of Inter Chassis Links and Cisco ASR9000v or Cisco ASR9000v-V2
as Satellite box.
• Software—Cisco IOS XR Software Release 5.1.1 or higher.
Offloading Service-policy on Physical Access Port
Perform these tasks to offload the service-policy on the physical access port. This procedure offloads the
service-policy in the ingress direction of the Satellite Ethernet interface.
SUMMARY STEPS
1.
configure
2.
class-map [type qos] [match-any] [match-all] class-map-name
3.
match precedenceprecedence-value [precedence-value1 ... precedence-value6]
4.
end-class-map
5.
policy-map [ type qos ] policy-name
6.
class class-name
7.
set qos-group qos-group-value
8.
exit
9.
end-policy-map
10.
interface type interface-path-id
11.
(Optional) l2transport
12.
nv
13.
service-policy input policy-map
14.
commit
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
78
Configuring QoS on the Satellite System
Prerequisites for QoS Offload Configuration
To Next Page
Loading...
Need help?
General
