Cisco ASR 9000 Series

•
fc-fe
•
fc-ne
•
ses-fe
•
ses-ne
•
sesr-fe
•
sesr-ne
•
uas-fe
•
uas-ne
Step 6
commit
Configuring the Thresholds for OTU Performance Monitoring
Parameters
Perform this task to configure the thresholds for OTU Performance Monitoring (PM) parameters.
SUMMARY STEPS
1.
configure
2.
controller otu [HO | LO] R/S/I/P
3.
pm [15-min | 24-hour] [fec | otn] [report | threshold] [ec-bits | uc-words] disable
4.
pm [15-min | 24-hour] [fec | otn] [report | threshold] threshold-type value
5.
commit
DETAILED STEPS
Step 1
configure
Step 2
controller otu [HO | LO] R/S/I/P
Example:
RP/0/RSP0/CPU0:router (config)# controller otu4 100/3/0/1
Enters the OTU4 controller configuration mode. Performance monitoring is enabled by-default for OTU controllers.
Step 3
pm [15-min | 24-hour] [fec | otn] [report | threshold] [ec-bits | uc-words] disable
Example:
RP/0/RSP0/CPU0:router (config-otu1)# pm 15-min fec report ec-bits disable
Specifies the PM interval for the OTU controller and set report value for the FEC layer.
Step 4
pm [15-min | 24-hour] [fec | otn] [report | threshold] threshold-type value
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
129
Configuring the Performance Monitoring Thresholds for the Satellite nV Optical System
Configuring the Thresholds for OTU Performance Monitoring Parameters