Cisco ASR 9000 Series

SUMMARY STEPS
1.
configure
2.
controller odu [HO | LO] R/S/I/P
3.
perf-mon [Enable | Disable]
4.
pm [15-min | 24-hour] otn [report | threshold] {rx-bit-err | rx-crc-err | rx-csf-stats | rx-inv-type |
rx-lfd-stats} enable
5.
pm [15-min | 24-hour] otn pathmonitor [report | threshold] threshold-type value
6.
commit
DETAILED STEPS
Step 1
configure
Step 2
controller odu [HO | LO] R/S/I/P
Example:
RP/0/RSP0/CPU0:router (config)# controller odu4 100/3/0/2
Enters the ODU4 controller configuration mode.
Step 3
perf-mon [Enable | Disable]
Example:
RP/0/RSP0/CPU0:router (config-odu4) # perf-mon enable
Enables the performance monitoring.
Step 4
pm [15-min | 24-hour] otn [report | threshold] {rx-bit-err | rx-crc-err | rx-csf-stats | rx-inv-type | rx-lfd-stats} enable
Example:
RP/0/RSP0/CPU0:router (config-odu4)# pm 15-min otn report rx-crc-err enable
Specifies the PM interval for the ODU controller and set report value for the OTN layer.
Step 5
pm [15-min | 24-hour] otn pathmonitor [report | threshold] threshold-type value
Example:
RP/0/RSP0/CPU0:router (config-odu4)# pm 15-min otn pathmonitor threshold uas-fe 8
Specifies the PM interval for the ODU controller and set threshold value for the OTN layer. threshold-type can have one
of the following values:
•
bbe-fe
•
bbe-ne
•
bber-fe
•
bber-ne
•
es-fe
•
es-ne
•
esr-fe
•
esr-ne
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
128
Configuring the Performance Monitoring Thresholds for the Satellite nV Optical System
Configuring the Thresholds for ODU Performance Monitoring Parameters