EasyManuals Logo
Home>Cisco>Network Router>ASR 9000 Series

Cisco ASR 9000 Series System Configuration Guide

Cisco ASR 9000 Series
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
PurposeCommand or Action
Defines the expected type of the attached satellite.
type type_name
Step 6
Example:
RP/0/RSP0/CPU0:router(config-satellite)#
satellite 200 type ? asr9000v Satellite
type
The satellite types are asr9000v, asr9000v2, asr901v, and asr903v.
For other supported satellite types, see Prerequisites for Configuration.
Specifies the IP address to assign to the satellite. ICPE sets up a
connected route to the specified IP address through all configured
ICLs.
ipv4 address address
Example:
RP/0/RSP0/CPU0:router(config-satellite)#
ipv4 address 10.22.1.2
Step 7
Specifies the secret password to access the satellite. In order to login
you must use root as the user name and password as the secret
password.
secret password
Example:
RP/0/RSP0/CPU0:router(config-satellite)#
secret <password>
Step 8
Saves configuration changes.end or commit
Step 9
Example:
RP/0/RSP0/CPU0:router(config)# end or
RP/0/RSP0/CPU0:router(config)# commit
When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
- Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns
the router to EXEC mode.
- Entering no exits the configuration session and returns the
router to EXEC mode without committing the configuration
changes.
- Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration changes.
Use the commit command to save the configuration changes to
the running configuration file and remain within the configuration
session.
Configuring the Host IP Address
This procedure gives you the steps to configure a host IP address on a loopback interface.
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
36
Configuring the Satellite Network Virtualization (nV) System
Configuring the Host IP Address

Table of Contents

Other manuals for Cisco ASR 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 9000 Series and is the answer not in the manual?

Cisco ASR 9000 Series Specifications

General IconGeneral
BrandCisco
ModelASR 9000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals