Cisco ASR 9000 Series System Configuration Guide

(config-l2vpn-bg-bd)#nv
(config-l2vpn-bg-bd-nv)#offload ipv4 multicast enable
This configuration needs to be enabled on both hosts participating in the Dual Host system of the Ring
topology.
Note
Configuration examples for Satellite nV multicast offload
These show command outputs provide the necessary details about multicast offload:
•
show igmp snooping group summary debug
•
show igmp snooping port group debug
•
show l2vpn forwarding bridge-domain mroute ipv4 detail location <>
•
show l2vpn forwarding bridge-domain mroute ipv4 hardware ingress detail location <>
•
show nv satellite multicast satellite <>
For more information on IGMP Snooping commands, see Cisco ASR 9000 Series Aggregation Services
Router Multicast Command Reference. For more information on L2VPN forwarding commands, see
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference
Note
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
112
Configuring Multicast Offload on the Satellite nV System
Configuring Satellite nV Multicast Offload

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model