Cisco ASR 9000 Series System Configuration Guide

Step 2
nv
Example:
RP/0/RSP0/CPU0:router(config)# nv
Enters the nV configuration submode.
Step 3
satellite satellite-id
Example:
RP/0/RSP0/CPU0:router(config-nV)# satellite 100
Declares a new satellite optical shelf that is to be attached to the host and enters the satellite configuration submode.
satellite-id is a number in the range of 100 to 65534.
Step 4
type type-name
Example:
RP/0/RSP0/CPU0:router(config-satellite)# type ons15454-m6
Defines the expected type of the attached satellite. nV optical satellites can have one of the following values:
•
ons15454-m6
•
ons15454-m2
•
ncs2002
•
ncs2006
Step 5
ip address { ipv4-address | ipv6-address }
Example:
RP/0/RSP0/CPU0:router(config-satellite)# ip address 1.2.3.4
Specifies the IP address (IPv4 or IPv6) used to connect to the satellite along with an optional Virtual Route Forwarding
(VRF) instance. Interface Control Plane Extender(ICPE) sets up a connected route to the specified IP address through
all configured inter-chassis links (ICLs).
Step 6
(Optional) vrf vrf-name
Example:
RP/0/RSP0/CPU0:router(config-satellite)# vrf mgmt
(Optional) Specifies the name of the VRF that contains the IP address used to connect to the satellite optical shelf.
Step 7
username string password { { 0|clear } cleartext-password | { 5|encrypted } encrypted-password | cleartext-password
}
Example:
RP/0/RSP0/CPU0:router(config-satellite)# username CISCO15 password otbu+1
Specifies the username and password to use to log into the interface shelf. The password can be entered in clear text or
hashed encrypted form. However, the password is always displayed in the encrypted format.
Step 8
(Optional) serial string
Example:
RP/0/RSP0/CPU0:router(config-satellite)# serial abcdrstv
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
118
Configuring the Satellite nV Optical Shelf System
Provisioning an Optical Application

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model