Cisco ASR 9000 Series System Configuration Guide

SUMMARY STEPS
1.
configure
2.
interface interface-name
3.
nv
4.
satellite-fabric-link satellite <id>
5.
ethernet cfm
6.
level
7.
continuity-check interval time
8.
end or commit
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/0RSP0/CPU0:router# configure
Step 1
Specifies the supported inter-chassis link interface types limited
by the connectivity provided on the supported satellites.
interface interface-name
Example:
RP/0/0RSP0RP0/CPU0:router(config)# interface
Gigabit 0/1/0/0
Step 2
Enters the Network Virtualization configuration mode.nv
Example:
RP/0/0RSP0/CPU0:router(config-if)# nV
Step 3
Specifies that the interface is an ICPE inter-chassis link.
satellite-fabric-link satellite <id>
Example:
RP/0/0RSP0RP0/CPU0:router(config-int-nv)#
satellite-fabric-link satelite 200
Step 4
Enters Ethernet Connectivity Fault Management (CFM)
configuration mode.
ethernet cfm
Example:
RP/0/0RSP0RP0/CPU0:router(config-int-nv)#
ethernet cfm
Step 5
Specifies the CFM level. It ranges from 0 to 7.level
Example:
RP/0/0RSP0RP0/CPU0:router(config-int-nv-cfm)#
level
Step 6
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
45
Configuring the Satellite Network Virtualization (nV) System
Configuring the Fabric CFM

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model