Cisco Catalyst 2950 - Page 646

Index
IN-4
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-12
configuring the power supply alarm
setting the power mode
3-4, 3-5
setting the power supply alarm options 3-5
configuring the temperature alarms
associating the temperature alarms to a relay
3-7
setting a secondary temperature threshold 3-6
default alarm configuration 3-4
displaying Catalyst 2955 switch alarms 3-11
enabling SNMP traps 3-11
FCS error hysteresis threshold 3-2
global status monitoring alarms
power supply alarm
3-2
temperature alarm 3-2
port status monitoring alarms
FCS bit error rate alarm
3-3
link fault alarm 3-3
port is not operating alarm 3-3
port not forwarding alarm 3-3
triggering alarm options
configurable relays
3-3
FCS Bit Error Rate alarm 3-3
methods to trigger 3-3
SNMP traps 3-4
syslog messages 3-4
caution, described xxviii
CDP
and trusted boundary
29-23
configuring 23-2
default configuration 23-2
described 23-1
disabling for routing device 23-3, 23-4
enabling and disabling
on an interface
23-4
on a switch 23-3
monitoring 23-5
overview 23-1
transmission timer and holdtime, setting 23-2
updates 23-2
Cisco 575-LRE CPE 1-8
Cisco Access Analog Trunk Gateway 1-21
Cisco CallManager software 1-16, 1-21
Cisco Discovery Protocol
See CDP
Cisco Intelligence Engine 2100 Series Configuration
Registrar
See IE2100
Cisco IP Phones
1-16
Cisco LRE 48 POTS Splitter (PS-1M-LRE-48) 1-8, 1-18
Cisco Network Assistant
See Network Assistant
Cisco Networking Services
See IE2100
Cisco SoftPhone software
1-16
CiscoWorks 2000 1-10, 27-4
class maps for QoS
configuring
29-30
described 29-6
displaying 29-39
class of service
See CoS
clearing interfaces
10-17
CLI
abbreviating commands
2-4
command modes 2-1
described 1-9
editing features
enabling and disabling
2-6
keystroke editing 2-7
wrapped lines 2-8
error messages 2-5
getting help 2-3
history
changing the buffer size
2-5
described 2-5
disabling 2-6
recalling commands 2-6
managing clusters 6-4
no and default forms of commands 2-4