Cisco Catalyst 2950 - Page 654

Index
IN-12
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-12
IGMP throttling
configuring
20-26
default configuration 20-24
described 20-23
displaying action 20-28
Immediate-Leave, IGMP 20-5
ingress port scheduling 29-9
Integrated Services Digital Network
See ISDN
Intelligence Engine 2100 Series CNS Agents
See IE2100
interface
number
10-4
range macros 10-7
interface command 10-4, 10-5
interface configuration mode 2-3
interfaces
Cisco IOS supported
1-9
configuration guidelines 10-11
configuring 10-5
configuring duplex mode 10-10
configuring speed 10-10
counters, clearing 10-17
described 10-15
descriptive name, adding 10-15
displaying information about 10-16
flow control 10-13
monitoring 10-16
naming 10-15
physical, identifying 10-4
range of 10-6
restarting 10-17, 10-18
shutting down 10-17
supported 10-9
types of 10-1
interfaces range macro command 10-7
interleave delay, LRE 12-20
Intrusion Detection System
See IDS
IOS command-line interface
See CLI
IP
named extended ACL
28-13
named standard ACL 28-13
numbered extended ACL 28-10
numbered standard ACL 28-9
IP ACLs
applying to
management interfaces
28-19
physical interfaces 28-20
extended, creating 28-10
for QoS classification 29-27
implicit deny 28-9, 28-12, 28-14
implicit masks 28-9
management interfaces, applying to 28-19
named 28-13
physical interfaces, applying to 28-20
standard, creating 28-9
undefined 28-18, 28-20
virtual terminal lines, setting on 28-19
IP addresses
candidate or member
6-3
command switch 6-2
discovering 7-26
See also IP information
ip igmp profile command
20-24
IP information
assigned
manually
4-10
through DHCP-based autoconfiguration 4-3
default configuration 4-3
IP multicast routing and IGMP snooping 20-2, 20-7
IP phones
and IEEE 802.1x authentication
9-8
and QoS 18-1
automatic classification and queueing 29-10
configuring 18-3
trusted boundary for QoS 29-23