Cisco CATALYST 2960

Index
IN-16
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
descriptive name, adding 12-37
displaying information about 12-40
flow control 12-29
management 1-5
monitoring 12-40
naming 12-37
physical, identifying 12-16
range of 12-18
restarting 12-41
shutting down 12-41
speed and duplex, configuring 12-28
status 12-40
supported 12-16
types of 12-1
interfaces range macro command 12-19
interface types 12-16
Internet Protocol version 6
See IPv6
inter-VLAN routing
34-1
Intrusion Detection System
See IDS appliances
inventory management TLV
26-3, 26-7
IP ACLs
for QoS classification
33-8
implicit deny 31-9, 31-13
implicit masks 31-9
named 31-13
undefined 31-19
IP addresses
128-bit
35-2
candidate or member 6-4, 6-12
classes of 34-4
cluster access 6-2
command switch 6-3, 6-10, 6-12
discovering 5-24
for IP routing 34-4
IPv6 35-2
redundant clusters 6-10
standby command switch 6-10, 6-12
See also IP information
ip igmp profile command
21-25
IP information
assigned
manually
3-14
through DHCP-based autoconfiguration 3-3
default configuration 3-3
IP phones
and QoS
15-1
automatic classification and queueing 33-21
configuring 15-4
ensuring port security with QoS 33-45
trusted boundary for QoS 33-45
IP Port Security for Static Hosts
on a Layer 2 access port
20-17
IP precedence 33-2
IP-precedence-to-DSCP map for QoS 33-64
IP protocols in ACLs 31-10
IP routing
disabling
34-4
enabling 34-4
IP Service Level Agreements
See IP SLAs
IP service levels, analyzing
32-1
IP SLAs
benefits
32-2
configuration guidelines 32-5
Control Protocol 32-4
default configuration 32-5
definition 32-1
measuring network performance 32-3
monitoring 32-6
operation 32-3
responder
described
32-4
enabling 32-6
response time 32-4
SNMP support 32-2
supported metrics 32-2