Cisco CATALYST 2960

Index
IN-17
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
IP source guard
and 802.1x
20-15
and DHCP snooping 20-13
and EtherChannels 20-15
and port security 20-15
and private VLANs 20-15
and routed ports 20-15
and TCAM entries 20-15
and trunk interfaces 20-15
and VRF 20-15
binding configuration
automatic
20-13
manual 20-13
binding table 20-13
configuration guidelines 20-15
default configuration 20-15
described 20-13
disabling 20-16
displaying
active IP or MAC bindings
20-20
bindings 20-20
configuration 20-20
enabling 20-16, 20-17
filtering
source IP address
20-13
source IP and MAC address 20-13
on provisioned switches 20-15
source IP address filtering 20-13
source IP and MAC address filtering 20-13
static bindings
adding
20-16, 20-17
deleting 20-16
static hosts 20-17
IP traceroute
executing
39-18
overview 39-17
IP unicast routing
assigning IP addresses to Layer 3 interfaces
34-4
configuring static routes 34-5
disabling 34-4
enabling 34-4
inter-VLAN 34-1
IP addressing
classes
34-4
configuring 34-4
steps to configure 34-3
subnet mask 34-4
with SVIs 34-3
IPv4 ACLs
applying to interfaces
31-18
extended, creating 31-9
named 31-13
standard, creating 31-8
IPv4 and IPv6
dual protocol stacks
35-4
IPv6
ACLs
displaying
37-8
limitations 37-2
matching criteria 37-3
port 37-1
precedence 37-2
router 37-1
supported 37-2
addresses 35-2
address formats 35-2
and switch stacks 35-6
applications 35-4
assigning address 35-7
autoconfiguration 35-4
configuring static routes 35-10
default configuration 35-7
defined 35-1
forwarding 35-7
ICMP 35-3
monitoring 35-11
neighbor discovery 35-4
SDM templates 36-1, 37-1