Cisco CATALYST 2960

9-23
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
Chapter 9 Configuring Switch-Based Authentication
Controlling Switch Access with RADIUS
| Code | Identifier | Length |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
| Authenticator |
| |
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Attributes ...
+-+-+-+-+-+-+-+-+-+-+-+-+-
The attributes field is used to carry Cisco VSAs.
CoA ACK Response Code
If the authorization state is changed successfully, a positive acknowledgement (ACK) is sent. The
attributes returned within CoA ACK will vary based on the CoA Request and are discussed in individual
CoA Commands.
CoA NAK Response Code
A negative acknowledgement (NAK) indicates a failure to change the authorization state and can include
attributes that indicate the reason for the failure. Use show commands to verify a successful CoA.
CoA Request Commands
This section includes:
• Session Reauthentication
• Session Reauthentication in a Switch Stack
• Session Termination
• CoA Disconnect-Request
• CoA Request: Disable Host Port
• CoA Request: Bounce-Port
Beginning with Cisco IOS Release 12.2(52)SE, the switch supports the commands shown in Table 9-4.
Session Reauthentication
The AAA server typically generates a session reauthentication request when a host with an unknown
identity or posture joins the network and is associated with a restricted access authorization profile (such
as a guest VLAN). A reauthentication request allows the host to be placed in the appropriate
authorization group when its credentials are known.
Table 9-4 CoA Commands Supported on the Switch
Command
1
1. All CoA commands must include the session identifier between the switch and the CoA client.
Cisco VSA
Reauthenticate host Cisco:Avpair=“subscriber:command=reauthenticate”
Terminate session This is a standard disconnect request that does not require a VSA.
Bounce host port Cisco:Avpair=“subscriber:command=bounce-host-port”
Disable host port Cisco:Avpair=“subscriber:command=disable-host-port”